Pump System
There are two independent air hydro grease pumps on this unit, set produce a maximum pressure of 10,000 psi. Both pumps have independent controls, air on-off, pressure control valve, pressure isolator and vent valve. An inter system isolator valve allows the operator to use both pumps to feed one line if required. The grease supply is via two wet centre Hosereels, whilst a third reel is used for grease return.

Grease Reservoir
The unit has a 290 litre stainless steel reservoir. A drain plug is fitted to the bottom of the tank to allow fluid to be drained when necessary. Both grease pumps are flange mounted allowing access to clean out the tank if required. A large hinged filler cap allows the operator to check the grease level and fill the tank using the supplied transfer pump.

Grease Injection Air Hydro Pumps
High output, low maintenance, single air head, air hydro pumps are used to supply fluid under pressure directly to the panel controls. The high pressure pumps are fitted with in-line lubricators.

Fluid Transfer Air Hydro Pump
An air hydro fluid transfer pump is provided, stored within the frame, this is used solely for transferring grease from 45 gallon steel drums into the reservoir of the grease unit. Care should be taken not to leave the pump running unattended, as the reservoir could be overfilled. The maximum grease level should be 40mm from the top of the reservoir. An in-line lubricator is present to ensure smooth operation of the pump.

Hand Pump
The hand pump for the Line wiper and Pack-off functions is made of stainless steel and totally maintenance free.

Pneumatic System
An automatic drain air filter is fitted to remove any impurities from entering the air system. A locked air regulator limits the air pressure to the pumps thus restricting the output grease pressure to 10,000 psi. A recommended minimum air supply of 90 psi is required to run the pumps efficiently.

Control Panel
Colour filled engravings ensure the stainless steel panel is easy to use by clearly identifying individual controls and depicting all functions. The panel is fitted with high quality stainless steel valves with Hy-pro stainless steel fittings used extensively throughout the system.
Protecting the control panel is a hinged door that opens through 270 degrees and secures against the side of the unit when access is required.

Hose Reels
TIS Hose Reels are designed specifically for long life and low maintenance. They are manufactured entirely from stainless steel and bronze and are provided with grease nipples for lubrication. The reels are fitted with a unique modular hand-wind recovery system that allows for smooth, effortless operation whilst rewinding the hoses.

To contact us about this item please click the Specifications box